The KS tuned 90mm Throttle Body Spray Plate fits all intake manifolds and throttle bodies that use the common 90mm bore and flange pattern such as the Skunk2 Ultra Intake manifold and sheet metal intakes using 90mm flange. The plate includes four stainless steel fittings that accept all brands of standard nitrous jets and will allow for dual stage wet shot or up to four stages dry. Each fitting leads to no less than five injection ports inside the bore of the plate and each shot can be as large as you can find a jet for.
*Tested for up to 200 HP per fitting.
KS tuned K-Series RBC/PRB Spray Plate
The KS tuned PRB/RBC Throttle Body Spray Plate fits both bolt patterns found on PRB and RBC K-series intake manifolds. The bore is 70mm and it works with DBW and cable throttle bodies. The plate includes two stainless steel fittings that accept all brands of standard nitrous jets and will allow for a dual stage dry shot or single stage wet shot. Each fitting leads to no less than five injection ports inside the bore of the plate and each shot can be as large as you can find a jet for.
©1999-2024 Swap Shop Racing. Rancho Cucamonga, CA. All rights reserved.
**Important Operational Message**
* WARNING: CANCER & REPRODUCTIVE HARM- www.P65WARNINGS.CA.GOV**Some products may be OFF-ROAD USE ONLY. Always check Leagality of Aftermarket Products with your Local State, County, and/ or City Authorities Before Purchasing.
