Skunk2 Ultra Race Intake Manifold K20A2 Silver Adapter RWD

The Skunk2 Ultra-Race Series Billet Intake Manifold, for Honda B16A/B17A/B18A/B18C/B20A Engines is the ultimate manifold for high horsepower street and race engines. Though the standard Ultra Manifold already allows for 8 injectors to be mounted using two fuel rails, we listened to the demands of racers for a Skunk2 Ultra Manifold with a top side 8-Injector single rail setup. All Ultra Manifolds feature tapered runners with trumpet profiled entries and plenums that have been designed and optimized using CFD and on the dyno. The short tapered high-volume runners combined with an oversized plenum runners favors maximum top end power over lower end power and response. The best part about this project was that the hard part was completed years ago when we spent countless hours on the dyno developing the original cast Skunk2 Ultra Manifolds. There was no reason to mess with a great and proven design. The manifold features the same Skunk2 Ultra high flowing runners and modular plenum design, which allows plenum volume to easily be increased using simple spacers, and the runners can be freely ported for additional flow and volume. Other than being made from billet, the only revisions we made were the injector mounting area. The versatility of this manifold allows enthusiasts and engine builders to tune the manifold combination to best suit their needs. Indeed, the billet coolness-factor combined with the fact this proven Ultra manifold design is only produced in limited quantities which makes this a special offering.

Skunk2 Racing Ultra Series Intake Manifolds are the phenomenal next generation manifolds for the aftermarket intake technology. Made from high-grade 356 aluminum alloy for a strong and lightweight design, CNC-machined for a precise fit, Ultra Manifolds are individually inspected for best quality assurance. The large 90mm throttle body opening, 87mm velocity stacks, high-velocity intake runners, with smooth transitions, modular design and years of engineering research and development allow the Ultra Series Manifolds to outflow the competition. Designed to be used with built, high-horsepower naturally aspirated or forced induction setups, the Skunk2 Ultra Series Intake Manifolds help provide a new affordable level of high-end intake technology to the marketplace.

Skunk2’s cast-aluminum Pro Series Intake Manifolds for Honda’s B-series/ H-Series/ K-Series engines are a direct-fit replacement for all B-series engines thanks to three separate flange designs and are compatible with all factory sensors and throttle bodies as large as 75mm. Pro Series Intake Manifolds offer horsepower and torque gains greater than competitors’ manifolds but without compromising mid-range power output.

Performance Throttle Bodies and Throttle Body kits.